gipuzkoakultura.net

Logo de la Diputación Foral de Gipuzkoa
Logotipo gipuzkoakultura

gipuzkoakultura.net

viernes 13 diciembre 2024





Bertan > Bertan 19 Cerámica popular en Gipuzkoa > Versión en inglés: Kilns
Printable PDF version [10,8 Mb]Acrobat icon

Kilns

146. Clay blocks.© Jose López
146. Clay blocks.© Jose López

The earliest means of firing we know of consisted of firing the vessels over an open fire. Amazingly, this procedure was still used up until the nineteenth century in a town near the Basque Country-Ordizan, in the province of Bearne. R. Coquerel says that a layer of dry straw was laid on an area about two metres in diameter on clay ground or gravel. A few thin branches were placed on top. A covering of ferns and unfired vessels was placed on top of these. This was followed by another layer of ferns and more vessels, and so until, to form a cone. The potters then set fire to the entire pile. Once the pieces had been fired, the heap was covered in ashes and sods to ensure slow cooling.

147. Boards mounted using clay blocks and bricks at the kiln of the Elosu pottery (Alava), in the Museum of Basque Pottery.© Jose López
147. Boards mounted using clay blocks and bricks at the kiln of the Elosu pottery (Alava), in the Museum of Basque Pottery.© Jose López

One of the most important developments in the firing process was the separation of the combustion and firing chambers, introduced some time in the fourth millennium BCE in Mesopotamia.

In his fascinating book, "Les Fours", Daniel Rhodes writes: While there were of course subsequent improvements, this arrangement was used in most kilns in Mediterranean countries and Europe until modern times.

148. Trivets ( txakurrek ) to separate the glazed or enamelled vessels.© Jose López
148. Trivets ( txakurrek ) to separate the glazed or enamelled vessels.© Jose López

Pictures on some Greek glasses show the kilns that were used in the fifteenth century BCE, and they are very similar to some in Navarre (Irunberri, Atarrabia, the old kiln in Tutera, etc.).

These are known as vertical kilns with an ascending draught. In the Iberian Peninsula they are also known as "Arab" kilns, since it appears that it was the Moors who first introduced them. In Asia (China, Japan, Korea, etc.), on the other hand, horizontal kilns were developed, in which the fire or combustion chamber and the stack were practically at the same level. These kilns were of better quality because they attained higher temperatures with a more uniform distribution of the heat.

149. Combustion chamber at José Ortiz de Zarate's kiln in Elosu. Note how the intense heat has vitrified the stones in the vault.© Jose López
149. Combustion chamber at José Ortiz de Zarate's kiln in Elosu. Note how the intense heat has vitrified the stones in the vault.© Jose López

The kilns we have seen in the Basque Country are practically square in plan, except for the one in Marino Gonzalez's pottery in Tafalla, and Carmelo Añon's modern kiln in Tutera, which were circular. Sadly, both of these constructions have since been demolished.

They were all open, except for those in Irunberri, Atarrabia and the old kiln in Tutera, whose firing chamber had a brick vault, with holes to let out smoke and fumes, and create a draught.

As we have said, the vessels were placed on tacas -cylindrical clay blocks-separating the enamelled or glazed vessels by means of fired clay trivets so that they would not stick together during firing. These were called txakurrek (dogs) in Zegama and some other potteries in the Basque Country. On fired plates and cups we can see three small unglazed patches. These were the palces were the vessel was supported on the legs of the trivets.

151. Plates and a bowl with names on them.© Jose López
151. Plates and a bowl with names on them.© Jose López
152. Bowl.© Jose López
152. Bowl.© Jose López
153. Bowls or  katilus .© Jose López
153. Bowls or katilus .© Jose López
150. Plates decorated with unusual motifs in blues and greens. Others are completely white and some have names painted on them.© Jose López
150. Plates decorated with unusual motifs in blues and greens. Others are completely white and some have names painted on them.© Jose López
154. Fully glazed  katilu  with handle.© Jose López
154. Fully glazed katilu with handle.© Jose López

The charge of vessels normally protruded out the top of the kiln, and this additional part was called the colme .

Once the kiln had been charged the doors of the firing chamber were bricked up and the colme was covered in broken roof tiles, remains of vessels from previous firings, etc.

The fire was then lit, gently at first, and later raised to a temperature of between 900º and 1000º C.

155. Bowls glazed only on the inside.© Jose López
155. Bowls glazed only on the inside.© Jose López

The most widely-used procedure for determining the condition of the vessels, consisted of removing some enamelled cups from the colme with a metal hook.

The vessels were thus checked about five times before the firing process was considered complete. They were usually fired for between 16 and 17 hours, and in some larger kilns, up to 23 hours.

In other potteries, as well as checking the test pieces, they also used small viewing holes ( visteros ) in the bricks used to block off the doors of the firing chamber.

156. Basins. Large ones were used to catch the blood when a pig was slaughtered. Others were used for washing up and for miscellaneous other uses.© Jose López
156. Basins. Large ones were used to catch the blood when a pig was slaughtered. Others were used for washing up and for miscellaneous other uses.© Jose López
157. Basin with spout, coated more in engobe than glaze.© Jose López
157. Basin with spout, coated more in engobe than glaze.© Jose López
159. Basin glazed inside and out, from Bergara.© Xabi Otero
159. Basin glazed inside and out, from Bergara.© Xabi Otero
158. Basin made by Epifanio Galdos, Uribarri Ganboa.© Jose López
158. Basin made by Epifanio Galdos, Uribarri Ganboa.© Jose López
160. Butter jar with carved decorations and a spout.© Jose López
160. Butter jar with carved decorations and a spout.© Jose López

When the potter saw that the pieces of broken pottery in the colme began to turn white, he removed the plugs blocking the holes and inserted a very dry stick. By the light of the burning stick he checked the condition of the enamel or glaze on the vessels. Once firing was complete, the mouth of the combustion chamber was blocked off to stop the draught and put out the fire.

It took several days for the pieces to cool sufficiently to be removed from the kiln.

Cracked pieces were called apeladas and were piled in a heap near the kiln (the testar), to be used in the colme in later firings.

Unsightly pieces were called reuses , ereuses or rauses . These were sold privately at a lower price.

161. Butter jar from the San Miguel farmhouse in Aritzeta, Bergarar.© Xabi Otero
161. Butter jar from the San Miguel farmhouse in Aritzeta, Bergarar.© Xabi Otero

Firing was a delicate operation. A south wind, the wrong distribution of the fire, incorrect tempering, etc. could put paid to hours of work, and mean a waste of materials: clay, enamels, fuel, etc. Daniel Rhodes says Potters did not look on their kilns as others craftsmen looked on their tools. Their kiln was the altar of a holocaust, a potential enemy, a destroyer, but also an ally with whom they must work.

Consequently the potters sought protection from on high, making crosses out of pottery shards on the inside walls of the firing chamber before charging the vessels, crosses on the top of the combustion chamber when lighting the kiln or at the end of the process, and crosses and on the rubble in the colme etc. They also said prayers or crossed themselves at certain points during the process, and it was quite frequent to hear an exclamation of "praise God" at the end of a successful firing.

162. Butter jar made in Narbaxa..© Jose López
162. Butter jar made in Narbaxa..© Jose López

In Ordizan, where firing was communal, families that had pieces in the fire knelt around it, and said certain prayers throughout the firing process. Whenever they heard a noise that suggested that something had broken, they all said in unison soule assieu -may it be the only one-and redoubled their prayers. Coquerel says it was quite a pagan ceremony and met with complete opposition from the village priest. The origins of the ritual must be as old as the potter's art.

165. Butter jar with lid.© Jose López
165. Butter jar with lid.© Jose López
164. Butter jar.© Jose López, Xabi Otero
164. Butter jar.© Jose López, Xabi Otero
163. Butter jar with carved patterns, made in Uribarri Ganboa.© Jose López
163. Butter jar with carved patterns, made in Uribarri Ganboa.© Jose López
Licencia Creative Commons. Pulse aquí para leerla
2024 Departamento de Cultura y Euskera- Diputación Foral de Gipuzkoa.
Para conectar con nosotros mediante skype pulse aquí
Logotipo Gipuzkoa.net. Pulsar para ir a la página de Gipuzkoa.net